This information should be provided by the company that provides your Internet, also known as an Internet Service Provider (ISP). After the router detects your Internet connection, you may need to enter information such as a username and password. Please wait while your router detects your Internet connection type. This wizard will guide you through a step-by-step process to configure your new D-Link router and connect to the Internet. Step 7: If this is your first time logging in to the router, the Setup Wizard will start automatically. Step 6: Open an Internet browser (such as Internet Explorer) and enter or into the address bar. Step 5: Power on the DIR-860L and wait until the ‘power’ LED on the front of the device turns green. Step 4: Plug in the power for your cable or DSL broadband modem and wait for two minutes while the modem initializes. Step 3: Connect your Cable/DSL modem to the Internet port on the DIR-860L Step 2: Connect an Ethernet cable from your computer/laptop to a LAN port (port 1,2,3 or 4) on the back of the DIR-860L Click Save Settings.Step 1: Unplug the power to your Cable/DSL Internet modem Step 11: You should now see the policy listed at the bottom under Policy Table. Step 10: Enable or disable Web Access Logging and click Next. Step 9: Select Filtering Method and click Next.
#Dlink router configuration mac
Step 8: Select the IP or MAC addresses of the machine(s) the policy applies to and click Next. Step 7: Select a Schedule and click Next. You will then have to set up a policy for the Website filter. Step 4: Next, click the Access Control Tab and check the Enable Access Control box. When you have finished, click Save Settings. Indicate the Websites you wish to block or restrict access to. Select the option “Deny computers access to ONLY these sites” under Configure Website Filter. Step 3: Click the Advance tab and Website Filter on the left hand side of the screen.
![dlink router configuration dlink router configuration](https://wirelessrouterexpert.com/wp-content/uploads/2018/06/Dlink-configuration-card.jpg)
#Dlink router configuration password
Step 2: Enter the User Name (admin) and password (blank by default), and then click OK or Log in. Step 1: Open your Web browser and type in the router IP address (192.168.0.1 by default). Note: After configuring the Wireless Network Settings, you will have to enter a personal identification number (PIN) generated from your wireless adapter in order to establish a proper connection between client and host. However, you will not know the security key, which is required if you add another device that doesn’t use WPS.Ĭonfigured mode: Both Wireless Network Settings and Wireless Security Mode must be configured, including the wireless security key. There is no need to enable Wireless Network Settings. Note: When you use unconfigured mode, all router settings will be added automatically. You will not have to create a wireless network name (SSID) or security key. Unconfigured mode: After setting up your wireless device with WPS and Push Button Configuration (PBC), simply press the WPS button on the side of the router. WPS is designed to support Wi-Fi-certified 802.11 networks. WPS automatically configures a wireless network with a network name (SSID), WPA security key and authentication. Wi-Fi Protected Setup (WPS) is a method of connecting to a wireless network that requires little configuration. This button is the Wi-Fi Protected Setup button.